Searching...

Matching results

    How to configure AirVantage to send SMS with a gateway using SMPP?

    This topic explains how to configure AirVantage to send SMS with a gateway using SMPP.

    Initializing Table Of Contents...

    Introduction

    The SMPP protocol (Short Message Peer-to-Peer) is the most commonly used protocol for short message exchange outside SS7 networks. AirVantage supports Versions 3.3 and 3.4 of SMPP.

    If you want to learn more about SMPP, have a look to the specification.

    Create an account

    • Start by creating a SMS account from the Administration.

    • Choose SMPP Gateway from the SMS Provider list.

    • Choose a name and complete the form with the information provided by your SMS Provider.

    The parameters are defined as follows:

    Parameter Description
    Type (Mandatory)

    RX, TX or TRX. This parameter corresponds to the mode used by AirVantage to connect to the SMS Gateway.

    • RX: bind_receiver mode is used (receive sms only)
    • TX: bind_transmitter mode is used (send sms only)
    • TRX: bind_transceiver mode is used (send & receive sms)
    • TRX can be used if you don’t have information from your provider for this parameter.

    Host (Mandatory) IP address or host name of the SMS Gateway.
    Port (Mandatory) TCP/IP port used to communicate with the SMS Gateway. There is no default port; you must get this information from your SMS Gateway provider.
    System Id (Mandatory) The username used to identify your account in the SMS Gateway.
    Password (Mandatory) The password of your account in the SMS Gateway.
    System type (Optional) May be required by your SMS provider to characterize an application or service. Can be left empty (default).
    Source TON (Optional)

    TON is short form for Type of Number configured as sender address in your account. It must be provided by your SMS Gateway provider.

    • 1: International number eg: +1 800 123456
    • 5: Alphanumeric
    • 6: Abbreviated
    • If you don’t know this number you can set it to 0 (Unknown).

    Source NPI (Optional)

    NPI is the short form for Numbering Plan Indicator configured as sender address in your account. It must be provided by your SMS Gateway provider.

    • 1: ISDN/telephone numbering plan
    • 6: Land Mobile
    • If you don’t know this number you can set it to 0 (Unknown).

    Source Address (Optional)

    Sender address configured in your account. It must be provided by your SMS Gateway provider.

    • If the number provided starts with a ‘+’ then enter in this field the number without the + and set TON and NPI to 1.

    Address TON (Optional) TON is short form for Type of Number used for destination address when AirVantage sends the SMS. This parameter has to be set to 1.
    Address NPI (Optional) NPI is short form for Numbering Plan Indicator used for destination address when AirVantage sends the SMS. This parameter has to be set to 1.
    Address Range (Optional) Same value as Source address except if your SMS Gateway provider gave you a range of addresses: enter the prefix of the range as provided.
    Version (Mandatory)

    Choose the version of SMPP that AirVantage should use to communicate with the SMS Gateway.

    • The default is 3.4.

    SMPP SMS Gateway providers tested by Sierra

    Sierra Wireless has successfully tested - and actually used in Production - several connections to SMS providers. Based on our tests and deployments in many countries around the world, we believe that guaranteed SMS delivery depends on how well the SMS Gateway is connected to the carrier you are using; for large carriers with heterogeneous networking infrastructures it may depend on which sub-network your SIM cards are connected to.

    The format of the Wake up SMS is binary Wap push, as defined in the OMA DM standard. We know that some carriers do not support SMS messages using this format on their network.

    For these reasons, the following lists are provided to help you getting started. However we advise you to test your preferred provider supports your actual networking environment.

    Some Sierra Wireless modules use a simple text SMS format: SL808xT, HL series, Q2698. For these modules, you can also use Twilio to send Wake Up SMS. Refer to the How-to: How to configure AirVantage to send SMS with Twilio?

    Multi-carrier SMS Gateways

    Name Website
    HSL http://www.hslsms.com
    Clickatell https://www.clickatell.com
    Telesign http://www.telesign.com/sms-voice-and-messaging

    Carrier SMS Gateways

    We recommend you contact these providers directly:

    Name Website
    Telenor connexion http://www.telenorconnexion.com
    AT&T http://www.business.att.com/enterprise/Family/mobility-services/machine-to-machine/
    Rogers http://www.rogersm2mbusiness.com/on/en/m2m-solutions
    KPN http://www.kpn.com/zakelijk/cloud/machine-to-machine-en/about-m2m.htm

    TOP